To swap in a new gasket, begin by unplugging the refrigerator. That'll help you track down the specific gasket for your particular refrigerator. Just remember to have your model number handy. Major appliance makers, like GE and Whirlpool, for example, sell replacement parts directly, including fridge gaskets. If this doesn't work, try installing a new gasket. Use a towel to dry the seal and the surrounding areas, and close the freezer. But first, check for the following two other things.Ĭause 2: A faulty seal can also result in unwanted frost.įix: First, try cleaning the seal around the inside of the freezer door using warm water, soap and a washcloth. If this doesn't solve the issue, you may have a malfunctioning defrost timer, for which you'll want a professional. This will ensure that the doors close on their own and that water is properly draining from the freezer and refrigerator. To resolve this, pull the refrigerator out from the wall and have someone lean the refrigerator back far enough for you to reach the two front pedestal feet. Try opening the freezer or fridge door and see if it closes on its own if not, this could be the cause of the frost. Once the line has defrosted, plug the refrigerator back in and push it back to the wall.Ĭause 1: Leaving the freezer door open too long can raise the humidity level inside the freezer, resulting in frost and ice buildup.įix: Obviously, try not to leave the freezer door open longer than necessary. If the clog is anything but clear, consult with a professional before trying to remove it. Simply leave the refrigerator unplugged for approximately 2 hours to remove the clog. If the water line is intact, but you see a translucent blockage, then ice is the culprit. You shouldn't overtighten their fittings, so you won't need that much strength. They're easy to hook up, though you might need to have a wrench on hand. You can find DIY water line kits for sale at your local hardware store ($10). Typically this line is a nylon tube with threaded compression fittings at both ends. If there's a break or tear in the line, replace the water supply line. Make sure this valve is closed, and look for any leaks, kinks or clogs in the plastic supply line. Fix: First, unplug the refrigerator and locate the shut-off valve, typically underneath the sink, behind the refrigerator or below the refrigerator in the basement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |